| Error Code | Meaning | Manual Solution | | :--- | :--- | :--- | | | Furnace did not reach start temp in time | Check door seal; pre-heat furnace for 10 min | | E-14 | Vacuum not reached after 2 min | Replace vacuum pump oil; clean fire tube | | E-22 | Thermocouple short circuit | Replace type S thermocouple (do not use type K) | | E-30 | Cooling fan failure | Check rear fan for dust; cycle power | | E-78 | Software lock | Enter Service mode > Reset Factory Defaults |
: The furnace is designed to be perfectly matched with Ivoclar ceramic materials, ensuring consistent, high-quality results for restorations. Operating the P90 (Based on Manual Data) Ivoclar Programat P90 Manual
Enter the specific program number for the ceramic material you are using (e.g., IPS Classic or IPS Design). | Error Code | Meaning | Manual Solution