Hw 130 Motor Control Shield For Arduino Datasheet Free !!top!! -
: Integrated resistors keep motors disabled during the Arduino's power-up sequence to prevent unintended movement. Power Jumper
🚀 No breadboard required; just plug and play. hw 130 motor control shield for arduino datasheet free
| Parameter | Value / Range | | :--- | :--- | | | L9110S (Dual H-bridge) | | Operating Voltage (Motor) | 3V – 12V DC | | Logic Voltage (VCC) | 5V (from Arduino) | | Peak Output Current (per channel) | 1.2A (Max) | | Continuous Output Current | 0.8A (recommended) | | Logic Input Voltage | High: 2.5V – 5V, Low: 0V – 0.5V | | PWM Frequency Support | 0 – 100 kHz (typical 1-10 kHz) | | Standby Current | < 0.1µA | | Operating Temperature | -20°C to +80°C | | Dimensions | 68.5mm x 53.3mm (Standard Uno shield size) | : Integrated resistors keep motors disabled during the
: 0.6A per bridge (1.2A peak) with thermal shutdown protection. Voltage Range : Motor supply voltage from 4.5V to 25V (though many variants are rated up to 12V-16V for safety). Dimensions : Approximately 69mm x 53mm. 5.imimg.com Pinout and Connectivity Voltage Range : Motor supply voltage from 4
// HW-130 Motor Shield Pin Definitions #define M1_SPEED 3 // PWM Pin for Motor A Speed #define M1_DIR 12 // Direction Pin for Motor A #define M2_SPEED 11 // PWM Pin for Motor B Speed #define M2_DIR 13 // Direction Pin for Motor B
The is a dual-channel DC motor driver shield designed for Arduino Uno, Leonardo, and similar boards. It is based on the L293D push-pull four-channel driver IC, allowing independent control of two DC motors (bidirectional) or one stepper motor. The shield is ideal for small robotics, smart car chassis, and educational projects.
The datasheet of the HW-130 Motor Control Shield provides detailed information about the shield's electrical and mechanical characteristics. Here are some key specifications: